I N S T R U C T I O N SAssemble pole.1Assemble the StandInsert bot tom and lock connector by rot atinghandle cloc kwise and pushing handle down.3Insert top by sliding tapered end into top of poleand push flush.4Find bottom and top of graphic and pole.2Verify the graphic is not twisted and that the graphiccovers the corners.Important:Note: The directions are the same for each shape.TopBottom(without connector)(with connector)Top(with light hole)Bottom(without hole)5Adjust lean to make vertical.-After prolonged periods of storage, the graphic may have wrinkles.To eliminate the wrinkles leave the stand set-up for several hours or use a steamer.**A Micro Steamer option is available.Helpful Tip: It’s easier to make the top connectionif the stand is held at waist level rather then if yourhands are held up over your head.www.AdvatumDisplays.com

ADVATUM allure Instructions Manual

Product

Learn More

Legal