ADTRAN TRACER Protection Switch Quick Start Manual

Contents

before you begin

ADTRAN TRACER Protection Switch Quick Start Manual Manual pdf 1 page image

1TRACER Monitored Protection Switch (MPS)Before you begin... Required Components• (2) TRACER Baseband Processor (BBP) and RF Converter (RFC) rackmount unitsOr,• (2) TRACER 4103 or 4203 integrated rackmount radio units• RS-232 interface cable and VT100 terminal (or a PC with VT100 emulator software) for connecting to the unit• (2) RS-232 (MALE) to RJ-45 (FEMALE) adapter (ADTRAN P/N 3196ADPT010) for creating the VT100 management chain (included inthe TRACER MPS shipment)• (2) 8-conductor RJ-45 to RJ-45 straight-through cable for creating the VT100 management chain (included in the TRACER MPSshipment)• (4) Straight-through T1 cables to connect the TRACER BBP or 4103/4203 T1 interfaces to the MPS (2 are included in each TRACERshipment)• (2) N-Type (MALE) to SMA (MALE) cables for connecting the antenna interfaces (TRACER units) to the TRACER MPS (included in theTRACER MPS shipment)• 18, 20, or 22 AWG dual-conductor cable for connecting the alarm contacts between the TRACER BBP or 4103/4203 and the TRACERMPS; also needed for connecting the MPS to an external alarm monitoring system• Antenna, mounting hardware, and feedline cable• 21 to 63 VDC power source (available from ADTRAN)• (2) Straight-through T1cables to connect the TRACER MPS to other CPE equipment (included in the TRACER MPS shipment)Or,• (2) T1 crossover cables to connect the TRACER MPS T1 interfaces to the public-switched network (included in the TRACER MPSshipment)About this Quick Start Guide...This guide contains information for installing your TRACER MPS system. ADTRAN recommends that the entire TRACER link be tested on alab bench prior to installation in the field.Verify the existence of an adequate microwave path for each hop or link to ensure that a point-to-point microwave system is feasible for yourparticular application. Record the frequency of your microwave system (2.4 GHz or 5.8 GHz) and be sure to configure the Frequency Bandmenu option appropriately before operating your TRACER MPS. For more details, refer to Reviewing the Menus on page 4.Quick Start Guide 61280300L1-13B October 2003