ADTRAN SHDSL E1 Installation And Maintenance Practice

Also see for E1: Quick start guide Quick start guide Installation instructions

Contents

ADTRAN SHDSL E1 Installation And Maintenance Practice Manual pdf 1 page image

Section 61225236L1-5AIssue 1, August 200361225236L1-5A 1Trademarks: Any brand names and product names included in this document aretrademarks, registered trademarks, or trade names of their respective holders.CONTENTS1. General ................................................................... 12. Description ............................................................. 13. Installation.............................................................. 24. Provisioning ........................................................... 45. Operation ................................................................ 56. Maintenance ........................................................... 97. Specifications ......................................................... 98. Warranty and Customer Service ............................ 9FIGURESFigure 1. SHDSL T1/E1 NTU Front Panel................ 1Figure 2. Typical System Application ....................... 2Figure 3. SHDSL T1/E1 NTU Menu Tree................. 6TABLESTable 1. Compliance Codes ...................................... 2Table 2. DB-9 Connector Pin Descriptions .............. 3Table 3. Front Panel LEDs ....................................... 4Table 4. Configuration Options List ......................... 7Table 5. E1 Port Statistics Definitions...................... 8Table 6. T1 Port Statistics Definitions...................... 9Table 7. SHDSL T1/E1 NTU Specifications............ 91. GENERALThis document is an installation and maintenancepractice for the ADTRAN Total AccessÆ SHDSL T1/E1 Network Terminating Unit (NTU). Figure 1 illus-trates the SHDSL T1/E1 NTU front panel, P/N1225236L1.The SHDSL T1/E1 NTU is a networkterminating module using Single-Pair High SpeedDigital Subscriber Line (SHDSL) technology totransport data over a single copper loop.Revision HistoryThis is the initial issue of this practice. Future changesto this documentation will be explained in thissubsection.2. DESCRIPTIONThe SHDSL T1/E1 NTU was designed for use as aremote unit to the Total Access 3000. The Total AccessSHDSL T1/E1 NTU provides an interface between theSHDSL network and the customerís Data TerminalEquipment (DTE) for applications such as LAN to LANbridging, Frame Relay circuit, and PABX termination.Figure 1. SHDSL T1/E1 NTU Front PanelThe SHDSL T1/E1 NTU is span powered with local DCpower auto-switchover. No adjustments, strapping, orconfiguration changes are necessary to power themodule. The SHDSL T1/E1 NTU configuration,testing, and performance monitoring is managed by theVT100 local management screen menus, remotely by anEOC terminal session, or also remotely by EOCmessage protocol initiated by the Total Access SHDSLT1/E1 LTU.1225236L1T1/E1SHDSLPWRTESTALMV.24T200 SHDSL T1/E1 Network Terminating UnitInstallation and Maintenance Practice