ADTRAN IP 706 Administrator's Manual

Also see for IP 706: Release notes Quick reference guide Quick reference manual User guide Release notes

Contents

ADTRAN IP 706 Administrator's Manual Manual pdf 21 page image

IP 700 Series Phone Administrator Guide Setting the Minimum Required Parameters6AOSAG0001-31A Copyright © 2011 ADTRAN, Inc. 21Server (Reg.x.Servers) Defines which pair of proxy and registrarservers should be used for this phone line.Config FileWeb InterfaceEnable Line (Reg.x.Enable) Enables or disables registration for a phoneline.Config FileWeb InterfaceDID (Reg.x.Did) Specifies the direct inward dialing (DID)number. Certain proxies may require a DIDnumber that is different from the user name forauthentication. If DID is not set, theReg.x.AuthUserId is used both forauthentication and as the DID number.Config FileWeb InterfaceRealm (Reg.x.Realm) Identifies the calling realm of the phone line.This is used to decide which type of dial plan toapply to this phone line.Valid entries are: GE, PE, GP, or GI.General External (GE) - Used for generalnon-PBX-type outside lines. Lines of this typeuse the DialPlanExternal dial plan.Private External (PE) - Used for private (fewusers) non-PBX-type outside lines. Lines of thistype use the DialPlanExternal dial plan.General PBX (GP) - Used for PBX callappearances that require an additional digit,such as 9 to be dialed to access outsidenumbers. Lines of this type use theDialPlanPbx dial plan.General Intercom (GI) - Used for intercom linesconfigured for key system operation. Lines ofthis type use the DialPlanIntercom dial plan.Config FileWeb InterfaceDial Plan If a dial plan is not specified, the default dialdelay (3 seconds after the last digit is dialed)will be used before dialed digits are sent to theproxy. You should specify DialPlanPbx,DialPlanIntercom, and/or DialPlanExternal asrequired by your line configuration settings(Reg.x.Realm). GE and PE realms useDialPlanExternal, GI uses DialPlanIntercom,and GP uses DialPlanPbx.Config FileWeb InterfaceSNTP Server IP Address(SntpServer)Optional. Identifies the server from which toretrieve the time.DHCPConfig FileWeb InterfaceTable 2. Minimum Parameters Required for Operation (Continued)Parameter Description Source