ADTRAN HDSL2 Installation And Maintenance Practice

Also see for 1223024L2: Installation and maintenance practice Manual

Contents

ADTRAN HDSL2 Installation And Maintenance Practice Manual pdf 21 page image

HDSL2 for General Distribution Installation and Maintenance Practice Provisioning61223HDSL2L2-5B 11Table 6. Provisioning OptionsProvisioning Option Option Settings Default Settings1. DSX-1 Line Build Out 1 0-133 feet, 133-266 feet,266-399 feet, 399-533 feet,533-655 feet, EXTERNAL0 to 133 feet2. DSX-1/DS1 Line Code B8ZS, AMI B8ZS3. DSX-1/DS1 Framing SF, ESF, Unframed, Auto ESF4. Force Frame Conversion Disabled, Enabled Disabled5. Smartjack Loopback Disabled, Enabled Enabled6. Loopback Time Out None, 120 Min 120 Minutes7. Latching Loopback Mode 2 T1 (Disabled), FT1 (Enabled) T1 (Disabled)8. DS1 Tx Level 0 dB, –7.5 dB, –15 dB 0 dB9. Span Power Enabled, Disabled Enabled10. Customer Loss Indicator 3 AIS, Loopback, AIS/CI AIS/CI11. Performance Reporting Messages None, SPRM, NPRM, AUTO (both) AUTO12. Loop Attenuation Alarm Threshold 0 (Disabled), 1-99 dB 30 dB13. SNR Margin Alarm Threshold 0 (Disabled), 1-15 dB 04 dB14. Remote Provisioning Disabled, Enabled Enabled15. Shelf Alarm 4 Disabled, Enabled Enabled2. External is used only for Kentrox shelves. Unit transmits 12-volt p-p to DSX panel.3. Latching Loopback Mode• T1 - When optioned for T1 mode, the unit does not respond to DDS Latching Loopback codes.• FT1 (Fractional T1) - DDS Latching Loopback operation is supported. The H2TU-C units which are in theHDSL circuit are treated as Identical Tandem Data ports and the HTU-R is treated as a different TandemData port.Note: When operating in FT1 mode and during periods of T1 loss of signal, LOS, or T1 AIS from the customerCI, the HDSL system will send in the network direction from the HTU-C a Fractional DS1 idle signalconsisting of a repeating 7E (HEX) byte payload within a framed/unframed T1 signal. In addition,when optioned for FT1 mode, the setting for Customer Loss Response is ignored.4. Customer Loss Indicator• AIS - Send AIS to network upon T1 loss of signal or T1 AIS from customer.• LPBK - HTU-R initiates a network loopback upon T1 loss of signal or T1 AIS from customer.• AIS/CI - HTU-R sends customer disconnect indication upon loss of signal, loss of synchronization, or receiptof T1 AIS from customer.Note: The CI is generated by transmitting the framing received from the network while overwriting thepayload with a repeating pattern. For applications where the DS1 is Extended Superframe, the datalink is overwritten with a Yellow Alarm that is interrupted once every second by a 100 milli-secondcode burst of 7E (HEX).5. Shelf Alarm is on the DDM+, 3192M, and 3192 Units only.