Advanced RF Technologies, Inc. 406.2.2 ADXV-HPR Installation ProcedureThe ADXV-HPR chassis mounts in a standard 19” (483mm) equipment rack. Allow clearance of 3” (76mm) at thefront and rear, and 2” (51mm) on both sides for air circulation. No top or bottom clearance is required.• Consideration:- Eight mounting holes (two holes at each corner of ADXV-HPR rack) are to attach it to the 19” rack.The ADXV-HPR must be securely attached to a rack that can support the weight of the ADXV.• Procedure- The following steps should be followed while mounting the ADXV-HPRVerify that the ADXV-HPR and Mounting holes are in good conditionSet the ADXV-HPR against the 19”rack and secure the unit with screwsVerify that ADXV-HPR is securely attachedConnect the GND cableConnect the RF coaxial cableConnect the PowerConnect the Optic cable
