29-1S E C T I O N 2 9Keypad Functions• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •In This Section General Information Arming Commands Access Control Delaying Closing Time Partition "Go To" Command Viewing Capabilities of a User Viewing Zone Descriptors Viewing Downloaded Messages Using the Built-in User's Guide Panic Keys Speed Key [D] (Macros) Manual Relay Activation Mode (#70 Mode) Instant Activation Mode (#77 Mode)• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •General InformationThe keypad allows the user to arm and disarm the system, and perform other systemfunctions, such as bypassing zones, viewing messages from the central station, anddisplaying zone descriptors. The system conditions are shown in the display window.When an alarm occurs, keypad sounding and external sounding will occur, and the zone(s) inalarm will be displayed on the keypad. Disarming the system (enter the security code andpress the OFF key) will silence both keypad and external sounders. After the system isdisarmed, the system displays any zones that were in an alarm condition during the armedperiod. To clear this display, simply repeat the disarm sequence.The keypads also feature chime annunciation, and 3 panic keys (for silent, audible, fire orpersonal emergency alarms) which can notify the central station of an alarm condition, ifthat service is connected.Arming CommandsThe following is a brief list of arming commands. For detailed information concerning thesefunctions, refer to the User's Manual.Display FaultedZonesTo arm the system must be in the READY condition (all zonesmust be intact). If the "NOT READY" message appears, press theREADY * key to display faulted zones.Arming Away Enter code + 2 (AWAY)Arming Stay Enter code + 3 (STAY) (all zones designated as zone types 4 and 10will be automatically bypassed).Arming Instant Enter code + 7 (INSTANT) (same as STAY without entry delay).Arming Maximum Enter code + 4 (MAXIMUM) (same as AWAY without entry delay).Disarming Enter code + 1 (OFF).Quick Arming Note that if QUICK ARM is enabled (field *29), the # key can bepressed instead of entering the security code, for any of the armingprocedures (Away, Stay, Instant, Maximum, etc.).
