Menu
ADEMCO 737-10 Installation Instructions Manual
   |
FLUSH MOUNTNo. 737-10 or 737-20:a) Select desired location inwhich to install speaker.b) Be certain there are no buiit-in obstructions and that there isadequate depth for speaker.c) Use template as a guide incutting out speaker opening.d) if screws are to be used formounting grille, set front ofgrille face down on flat surfaceand punch out (4) starter holeswhere required. Use large nailor other punch type device.e) if adhesive is used for mount-ing, be certain the adhesive is ofthe type that does not damageplastic.1) Connect wires to terminalsand mount per illustration atright and WIRING section onpage 3.SURFACE MOUNTNo. 737-10 only:(No. 737-20: n n o tbe surface mountedas indicated here)a) Select desired location onwhich to surface mount thespeaker,b) No cutout is required. Usesurface mount point@to locateand drill the four mounting hoiesfor the surface mount brackets;use a 3/32” drill. Partially mountscrews into holes.c) Attach brackets to surfaceusing the slotted feet. Bracketsshould be positioned for thedesired speaker tiit...up ordown. Tighten screws.d) Connect wire to speaker ter-minals and mount speaker andgrille to brackets per illustrationat right and WIRING section onpage 3.-10 or6 FLUSHUSE (2) LONGSCREWS FOR SURFACE -Q’K 1/’5 Y3--/w-s----------313www.PDF-Zoo.com |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved