Menu
ADDER AdderLink X100 User Manual
Also see for AdderLink X100: User guideUser guide
                   | |
Contents
| 
welcome contentsinstallation& operationspecialconfigurationfurterinformationRadio Frequency EnergyA Category 5 (or better) twisted pair cable must be used to connect the units inorder to maintain compliance with radio frequency energy emission regulationsand ensure a suitably high level of immunity to electromagnetic disturbances.All other interface cables used with this equipment must be shielded in orderto maintain compliance with radio frequency energy emission regulations andensure a suitably high level of immunity to electromagnetic disturbances.European EMC directive 89/336/EECThis equipment has been tested and found to comply with the limits for a classA computing device in accordance with the specifications in the Europeanstandard EN55022. These limits are designed to provide reasonable protectionagainst harmful interference. This equipment generates, uses and can radiateradio frequency energy and if not installed and used in accordance with theinstructions may cause harmful interference to radio or television reception.However, there is no guarantee that harmful interference will not occur in aparticular installation. If this equipment does cause interference to radio ortelevision reception, which can be determined by turning the equipment onand off, the user is encouraged to correct the interference with one or moreof the following measures: (a) Reorient or relocate the receiving antenna. (b)Increase the separation between the equipment and the receiver. (c) Connectthe equipment to an outlet on a circuit different from that to which the receiveris connected. (d) Consult the supplier or an experienced radio/TV technician forhelp.FCC Compliance Statement (United States)This equipment generates, uses and can radiate radio frequency energyand if not installed and used properly, that is, in strict accordance with themanufacturer’s instructions, may cause interference to radio communication.It has been tested and found to comply with the limits for a class A computingdevice in accordance with the specifications in Subpart J of part 15 of FCC rules,which are designed to provide reasonable protection against such interferencewhen the equipment is operated in a commercial environment. Operation of thisequipment in a residential area may cause interference, in which case the user athis own expense will be required to take whatever measures may be necessaryto correct the interference. Changes or modifications not expressly approved bythe manufacturer could void the user’s authority to operate the equipment.Canadian Department of Communications RFI statementThis equipment does not exceed the class A limits for radio noise emissions fromdigital apparatus set out in the radio interference regulations of the Canadiandepartment of Communications.Le présent appareil numérique n’émet pas de bruits radioélectriques dépassantles limites applicables aux appareils numériques de la classe A prescrites dansle règlement sur le brouillage radioélectriques publié par le ministère desCommunications du Canada. |
Related manuals for ADDER AdderLink X100
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved