ADDER ADDERLink INFINITY 101T Quick Start Manual

ADDER ADDERLink INFINITY 101T Quick Start Manual Manual pdf 1 page image

ALIF RXALIF RXALIF RXGigabitEthernetALIF101TWelcomeThis quick start guide covers some of the key points of the ALIF101T unit. Full user details and setupinstructions can be found at www.adder.com/en/kvm-solutions/adderlink-infinity-101tInitial configurationPlease see the next page for Connection details.ALIF units can be linked in two mains ways: Direct or Networked.Direct linkingWhere ALIF transmitters and receivers are directly linked to each other, very little configuration actionis required, provided that they both have their factory default settings in place - just link them together.If the standard settings have been changed in a previous installation, you merely need to perform amanual factory reset on each unit. Please see the next page for further details.ADDERLink INFINITY 101TQuick Startcontinued overleaf© 2020 Adder Technology Limited • All trademarks are acknowledged.Part No. MAN-QS-ALIF101T-ADDER_V1.0www.adder.comALIF RXALIF101TNetworked linkingWhere ALIF units are connected via networked links, you can either configure them individually, orconfigure them collectively using an AIM server:• Configuring networked ALIF units individually - You need to specify the network addressesof the ALIF units so that they can locate each other. This is done by running the ADDERLinkINFINITY browser-based configuration utility on a computer system linked to the same networkas the ALIF units. Please see the next page for further details.• Configuring networked ALIF units collectively - The ADDERLink INFINITY Management(AIM) server allows you to configure, control and coordinate any number of ALIF transmitters andreceivers from a single application. See adder.com for details.IMPORTANT:When using AIM to configure ALIF units, it isvital that all units that you wish to locate and control areset to their factory default settings. Otherwise they willnot be located by the AIM server. If necessary, perform amanual factory reset on each ALIF unit. See next page.Note: If you are using one or more ALIF101T transmitterswithin an installation managed by an AIM server, the AIMserver must be running firmware version 4.12 or above.

/ 2

Related manuals for ADDER ADDERLink INFINITY 101T