Menu
AD DESIGNS ADP700.1 Instruction Manual
                                 | |
ADMP 900.61) Set BAL/UNBAL switch to suit the source. DO NOT set to unbalanced if using a head unitwhich has BTL outputs. Please refer to page 30 on how to do this.Channels 1+2 has two modes of operation.A) Set the PUSH SWITCH out to FR and these channels run in full range with the LEVEL controlbeing active.B) Set the PUSH SWITCH in to HP and these channels run in High Pass mode.Channels 3+4 have four modes of operation.A) Set the PUSH SWITCH out to HP and set the frequency to 10Hz. The channels now runeffectively in full range.B) Setting the HP crossover to a frequency higher than 10Hz allows these channels to operatein High Pass mode.C) Set the PUSH SWITCH in to LP/BP, set the High Pass crossover to 10Hz and set the LowPass crossover to the desired frequency and these channels operate in Low Pass mode.D) Setting the High Pass crossover to a higher frequency than 10Hz allows these channels tooperate in Band Pass mode.Channels 5+6 have four modes of operation.A) Set the SLIDE SWITCH to HP and set the frequency to 10Hz. The channels now runeffectively in full range.B) Setting the HP crossover to a frequency higher than 10Hz allows these channels to operatein High Pass mode.C) Set the SLIDE SWITCH to LP/BP, set the High Pass crossover to 10Hz and set the Low Passcrossover to the desired frequency and these channels operate in Low Pass mode.D) Setting the High Pass crossover to a higher frequency than 10Hz allows these channels tooperate in Band Pass mode.E) Setting the SLIDE SWITCH to MONO mixes the channels to mono and invokes the REMOTEport. The channels continue to operate in LP/BP mode.2) Set the LEVEL controls to suit the signal source’s output level.3) The easiest way to set the LEVEL control is to set the volume control of the signal source toabout 85-90% of it’s maximum and then whilst playing your favourite CD, set the LEVEL controluntil the APEC LED just flashes on the loudest peaks.4) If the remote level controller is used, set the LEVEL control close to fully CW.Page 20 |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved