OneStart

Menu

ACTi KCM-7911 Installation Manual

Also see for KCM-7911: Hardware user manualHardware manualInstallation guide

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Contents
  1. Table Of Contents
  2. Installation Procedures
  3. Step 1: Prepare for Waterproof Installation
  4. Step 2: Prepare the Camera for Installation
  5. Step 3: Install the Gang Box
  6. Step 4: Install the Gang Box Converter
  7. Step 5: Connect the Cable(s)
  8. Waterproof Solution with Conduit
  9. Step 6: Install the Camera
  10. Step 7: Connect to Network
  11. Step 9: Close the Dome Cover
  12. Appendices
  13. How to Connect a Power Adapter (Optional)
  14. How to Connect DI/DO Devices (Optional)
  15. How to Connect Audio Devices (Optional)
  16. Safety Information
ACTi KCM-7911 Installation Manual Manual pdf 31 page image
www.acti.comInstallation Guide31How to Connect Audio Devices (Optional)Depending on your surveillance needs, you may connect audio input or output device, such as anactive microphone or speaker, to your camera. In this case, you need to connect the audioinput/output device to the supplied audio terminal block.To connect audio input / output devices, map the pins to one of the pin combinations below:Device Pin Mapping InstructionsAudio Output1 GND Connect the wires of the audio output device to GND(Pin 1) and AUDIO.OUT (Pin 2).2 DI1Audio Input3 GND Connect the wires of the audio input device to GND(Pin 3) and AUDIO.IN (Pin 4).4 DI2Press and hold the orange tab as you insert the wire through the pin slot, then release the orangetab to secure the wire.NOTE: For more information about AUDIO in connections, please refer to the Knowledge Basearticle How to Use Audio-in of ACTi Cameras, downloadable from the link below(http://www.acti.com/support/KnowledgeBase/outside/detail.asp?KB_ID=KB20100114003).4321
/ 34
This manual is suitable for:
KCM-7911
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved