OneStart

Menu

ACR Electronics 2204B Product Support Manual

Also see for 2204: Product support manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Contents
  1. Table Of Contents
  2. Description
  3. Battery Monitor
  4. Maintenance
  5. Repair
  6. Assembly
  7. Technical Data
  8. Parts List
  9. Appendix
ACR Electronics 2204B Product Support Manual Manual pdf 9 page image
ACR ELECTRONICS, INC.Product Support ManualPortable Safety MegaphoneY1-03-0340 Rev. C Company Confidential 95.2 Assembly1. Attach horn and speaker assembly to megaphone subassembly. Ensure alignment with locationpins. Pass speaker wires through the provided slot.2. Plug speaker connector into the “out” header on PCB.3. Push entire assembly gently into the housing until it stops. Turn clockwise 45° and push all theway in. Turn counterclockwise 45° and align holes.4. Secure with screws. Torque to 3 in/lb.5. Replace volume control knob on volume control shaft. (does not apply to ACR/EM-2BA)6. Plug the alarm plug attached to lanyard into jack in the side of the case near volume control.(ACR/EM-1A only)7. Replace the six batteries in three tubes at microphone end of megaphone case.CAUTION: Observe polarity of batteries during installation procedure (see instructions onbattery tubes).8. Replace microphone and mouthpiece assembly. Align keyway, and secure with the threesetscrews.9. Assembly is complete. Test unit in accordance with Section 4.1.
/ 13
This manual is suitable for:
220422082204B22062206B2208B
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved