ACP RFS518TS Quick Start & Reference Manual

Also see for RFS518TS: Owner's manual

ACP RFS518TS Quick Start & Reference Manual Manual pdf 1 page image

Refer to Product Safety Manual for Safety StatementsComplete Owner’s Manual available onlineManual OperationTo cook food using a specific entered time and power level:1. Open oven door and place food in oven. Close door.2. Press TIME ENTRY pad and enter cooking time.3. Press a power level pad to change power level if desired (somemodels).• COOK LEVEL displays with the power setting.4. If stage cooking is desired, press TIME ENTRY pad and repeat steps2 through 4, (some models).5. Press START pad.6. At end of cooking cycle oven beeps and shuts off.Programming Items1. Open oven door.2. Press and hold pad 1 for approximately 5 seconds.3. Press pad to be reprogrammed.4. Enter cooking time by using the number pads.5. Press a power level pad to change power level if desired.6. If stage cooking is desired, press TIME ENTRY pad.• Display briefly shows the stage number.• Display changes to cook time and power level for the next stage.7. Enter cook time and power level as in steps 4 and 5 (some models).• To enter another cooking stage for that pad, press TIME ENTRY padagain.• Up to four different stages can be programmed (some models).8. Press START pad to set new programming changes to the pad.NOTE: To discard changes, press STOP/RESET pad or close oven door.Quick Start Reference GuideSo...how do I use it? (Electronic Control)QTY 2XProgramming(some models)To change the cooking factor:1. Open oven door.2. Press and hold pad 1 forapproximately 5 seconds.3. Press pad to be reprogrammed.4. Press the QTY 2X pad.5. Press a numbered pad tochange the cooking factor.• Cooking factor can be set from10% to 100%.• Default is 80%.• Pad 5 would change thecooking factor to 50%.6. Press START pad to savechanges.QTY 2X Pad (some models)1. Open oven door and place food in oven. Close door.2. Press QTY 2X pad.3. Press desired preprogrammed pad or pad sequence.4. Oven begins cooking. Displayed cooking time is the total of originalcooking time and added 2X time.CLEAN FILTERThis oven displays CLEAN FILTER at userdefined intervals. When the messagedisplays ACP recommends cleaning theair filter thoroughly. Cleaning the airfilter will not shut off the message.The message will stop displayingautomatically after 24 hours. Dependingon microwave use and environmentalconditions, the filter may need to becleaned more frequently. Once thefrequency is determined, set the optionfor the appropriate time frame.PreprogrammedPadsTo cook food usingpreprogrammed cookingsequences:1. Open oven door and place foodin oven. Close door.2. Press desired pad.3. Oven begins to cook.4. At end of cooking cycle ovenbeeps and shuts off.The switching operation of this microwave oven can cause voltage fluctuations on the supply line. The operation of this oven underunfavorable voltage supply conditions can have adverse effects. This device is intended for the connection to a power supply systemwith a maximum permissible system impedance Zmax of 0.10 Ohms at the interface point of the user’s supply. The user has toensure that this device is connected only to a power supply system which fulfills the requirement above. If necessary, the usercan ask the public power supply company for the system impedance at the interface point.Oven Wall ClearancesA—For North American (UL/CSA) models, allow at least2” (5.1 cm) of clearance around top of oven. ForInternational (50 Hz) models, allow at least 12” (30cm) of clearance around top of oven. Proper airflow around oven cools electrical components. Withrestricted air flow, oven may not operate properly andlife of electrical parts is reduced.B—Allow at least 2” (5.1 cm) between air discharge onback of oven and back wall.C—Allow at least 2” (5.1 cm) of clearance around sidesof oven.Accelerated Cooking Products