Menu
ACO QuARTz Lightline Quick Start Manual
  |
ACO L i g h t l i n eQuARTz by ACOShowerDrain LightlineInstallation & OperationProduct DescriptionACO Lightline contains two low-voltage battery-operated LED units which fit directly into theQuARTz by ACO ShowerDrain channel grating. These units will come on automatically assoon as they come in contact with water and will go off approximately two minutes afterthe shower is turned off.Charging the LED UnitThe LED unit must be fully charged before installing for the first time. Make sure the LEDunit is clean and dry, then insert it into the charger as shown in the picture below. Note theLED unit profile orientation before fitting it into the charger.Connect the main adaptor to the charger and turn the power on. Control indicators will beginto blink. The charging process can take up to 18 hours to complete. The charging is completewhen the control indicator stops flashing and remains continuously illuminated.NoteThe in dicators will blinkquickly if the charge level in the LED unit islow. If the indicators continue to blink quicklyfor more than one hour, then the LED unit isdefective and should be replaced.Under normal conditions of use, a fully -charged module should last approximatelythree months before needing a replacement.For optimum performance, always keepthe LED unit fully charged to preserve itslifespan.Control indicatorsInstalling the LED Unit1. Remove the grating from the showerchannel.2. Remove the grating plastic locks fromthe sides of the grating and insert the LEDunit, making sure the LEDs are facingtoward the center of the grating while theangled top faces upward allowing water todrain freely.on the charging unit |
Related manuals for ACO QuARTz Lightline
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved