ACME Xperior 700SZ Spot User Manual

Contents

ACME Xperior 700SZ Spot User Manual Manual pdf 11 page image

10CCAUTION: Never unscrew the screws of the rotating gobo as the ball bearing willotherwise be opened!Please follow the steps below to insert/change rotating gobos1. Open the cover by loosening the fastening screws on the cover.2. Push the gobo plate (follow the direction 1) and gently pull out the plate (follow thedirection 2).3. Take out the ring with an appropriate tool. Do not touch the surface of the glass gobo.4. Remove the original gobo and inset a new one (glazy side towards the lamp). Insert thering to secure it in the gobo holder.5. Install the gobo plate back into the gobo wheel. Make sure the gobo plate is installedunder the pressure plate.5.2 LampMSR/ MSD Gold 700/2 MiniFastFity Because of its high internal pressure, there might be a risk that the Dischargelamp would explode during operation. The lamp emits intense UV radiation whichis harmful to the eyes and skin. The high luminance of the arc can cause severedamage to the retina if you take a close look at the lamp.y To protect the lamp, always turn off the lamp first (via control panel or DMXcontroller) and let the unit run at least five minutes to cool down before switchingoff the mains supply. Never handle the lamp or luminaries when it is hot.y Do not touch the bulb with bare hands. If this happens, clean the lamp withdenatured alcohol and wipe it with a lint free cloth before installation.y The lamp generates UV radiation. Never operate the lamp without appropriateshielding.y When lighting up, the lamp operates at high pressure and there is a slight risk of arc