ACME XP-1200F User Manual

Contents

ACME XP-1200F User Manual Manual pdf 7 page image

XP-1200F13-1. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120-ohm1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it inthe DMX-output of the last unit.2. Connect the unit together in a “daisy chain” by XLR plug cable from the output of the unitto the input of the next unit. The cable cannot be branched or split to a “Y” cable. DMX512 is a very high-speed signal. Inadequate or damaged cables, soldered joints orcorroded connectors can easily distort the signal and shut down the system.3. The DMX output and input connectors are pass-through to maintain the DMX circuit,when one of the units’ power is disconnected.4. Each lighting unit needs to have a DMX address to receive the data by the controller.The address number is between 0-511 (usually 0 & 1 are equal to 1).5. The end of the DMX 512 system should be terminated to reduce signal errors.6. 3 pin XLR connectors are more popular than 5 pins XLR.3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin4, Pin5not used.7.2 Dedicated ControllerIF-series has 6 channels for international protocol DMX512. It can finish all operations viadedicated controller without using other controllers. When the power is switched on, theprojector automatically starts to run the self-test. After finishing these, the fixture is ready foroperation.ATTENTIONOnly connect the universal controller to the “DMX IN” connector, or it wil burnt out!Termination reduces signal errors and to avoid signal transmission problems andinterference. It is always advisable to connect a DMX terminal (Resistance 120 ohm 1/4Wbetween pin2 (DMX-) and pin3 (DMX+) of the last fixture).XP-1200F6-3. Technical SpecificationPower supply- 230V~50/60HzLamp- MSI 1200W/S / HMI 1200/S K SFc10-4Optical system- High efficiency optical system- High quality optical lens and dichroic colors- Beam angle: 13°Shutter/Dimmer- Blackout, 0~100% smooth dimming and strobe speed variable (1~12 flashes per second)Color Wheel- 8 dichroic colors plus white color- Rainbow effect at variable speedsColor Temperature- Standard 6000K, adjustable 5600K and 3200KDMX Channels Luminous intensity: (HMI 1200W)Standard DMX512 signaladdressing and controlled byany universal DMX controllerChannel 1 = ShutterChannel 2 = IrisChannel 3 = ColorChannel 4 = Color temperatureChannel 5 = DimmerChannel 6 = Focus

/ 10

Related manuals for ACME XP-1200F