Menu
ACME REED A40HP Quick User Manual
  |
REED A40HP Quick User Guide pg 1Turn on the Key Switch.Pull out the Emergency Stop (E-Stop) Switch.Push and hold the Start Button to start theengine.Turn on the Horn Switch to deactivate theE-Stop Light. If the E-Stop Light is ON, thepump will not operate.Ensure that the Forward/Reverse Switch is atFWD.Start pumping by turning on the PumpSwitch. The S-Tube will start turning.1.2.3.4.5.6.Starting the PumpTurn off the Pump Switch.Turn the Forward/Reverse Switch to REV.Turn on the Pump Switch to start reversingand removing the pressure.Continue reversing until the Drive CylinderPressure Gauge reaches 0 beforedismantling. DO NOT open the outlet & pipesif there’s any pressure shown in pressuregauge.1.2.3.4.Pumping in ReverseControl Panel:1. Hour Meter2. Emergency Stop (E-Stop) Button3. Start Button4. Key Switch5. Remote/Local Control Mode Switch6. High/Low RPM Switch7. Horn Switch8. Pump Switch9. Forward/Reverse Switch10. Stroke Change Switch2 3 45 7 916 8 10When the E-Stop Light is on, thepump will not operate |
Related manuals for ACME REED A40HP
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved