ACME Dynamic 25 Spin LED?GF25 User Manual

Also see for Dynamic 25 Spin LED?GF25: User manual

Contents

ACME Dynamic 25 Spin LED?GF25 User Manual Manual pdf 6 page image

5A3. LED:DMX On DMX input presentMASTER On Master ModeSLAVE On Slave ModeSOUND Flashing Sound activation4. Button:MENU To select the programming functionsDOWN To go backward in the selected functionsUP To go forward in the selected functionsENTER To confirm the selected functions5. Function Display: Used to show the various menus and the selected functions.6. DMX IN: For DMX512 link, use 3‐pin XLR plug cable to connect to the DMX controller andinput the DMX signal;7. DMX OUT: For DMX512 link, use 3‐pin XLR plug cable to link the next fixture and output theDMX signal;8. Microphone: Used to receive music for the sound activation;9. Only for remote control: Used to connect to the optional CA‐8 to control the unit for Standby, Function and Mode function;10. Only for wireless receiver: Used to connect to the optional CA‐9 to control the unit forStand by, Function and Mode function;3.2 Main FunctionTo select any functions, press the MENU button until the required function is showing on thedisplay. Select the function by pressing the ENTER button and the display will blink. Use theDOWN and UP button to change the mode. Once the required mode has been selected, press theENTER button to setup to go back to the functions without any changes press the MENU buttonagain. Hold and press the MENU button for one second or wait for one minute to exit the menumode.The main functions are shown below: