37y Click ( ) each frame on Resolution column to select recording resolution of a corresponding camera. You may select one of704x480, 704x240, and 352x240.y Click ( ) each frame on Frames column to select recording rate of a corresponding camera. Recording rate varies bycamera. Below lists the maximum recording rate of each camera.NTSC(PAL) 352x240 704x240 704x4804 Channel DVR 120(100) 60(50) 30(25)8 Channel DVR 240(200) 120(100) 60(50)16 Channel DVR 480(400) 240(200) 120(100)y Click ( ) each frame on Quality column to select recording quality of a corresponding camera. You may select one ofSuper, High, and Std.y Click ( ) each frame on Duration column to select recording duration (i.e., 1 second ~3 hours) of a corresponding camera.y Choose ‘OK’ to confirm the setting.4.5.2 Scheduley Please click ( ) RECORD>Schedule.y Each weekday is composed of 24 ‘Time blocks’. Each block represent 1 hour.y Click ( ) Camera frame to select Camera No. 1.y Please set the recording mode as follows:① Check (a check box next to your desired recording mode (i.e., Continuous, Alarm, Motion, and PreAlarm)). If you want tostop recording, please clear all check boxes.② Click block, row, column or all (square box) to register your desired recording mode.– Click ( ) a block, and only the block will be registered.– Click ( ) a row (S~H), and the entire row will be registered.– Click ( ) a column (00~23), and the entire column will be registered.– Click ( ) all (square box (between ‘S’ and ‘00’), and all the rows/columns will be registered.y Repeat the procedure for Camera Nos. 2 to 16. If you want every camera to have the same mode, please click ( ) Copy toAll Camera.y Below lists symbols of the respective recording modes.ContinuousAlarm InAlarm In / ContinuousAlarm In / PreAlarmMotionMotion / ContinuousMotion / PreAlarmMotion / Alarm InMotion / Alarm In / Continuous