Menu
ACE RC Sky Commander T4A 8418 Instruction Manual
            | |
44Radio installationBefore installing your radio into your model, connect the receiver, servos,and switch harness/battery pack as shown. In addition to checking for properoperation, this "bench test" will help you to become familiar with the operationof your radio. After connecting the model components, extend both thetransmitter and receiver antennas to their full length. Begin by turning onthe transmitter, and then turn on the receiver switch. Make sure that allservos and trims levers are operating, and take a few moments to "play"with your system. After completion of your bench testing, turn off the receiver,followed by the transmitter.WARNINGAlways follow the "transmitter on first, off last" procedure. A good wayto remember this is to remind yourself to always have your receiver"listening" to the transmitter. If you turn the transmitter off prior toturning off the receiver, the receiver has nothing to "listen to", andthis condition can sometimes damage the servo output gear trainbecause of "jitters" or excessive servo travel beyond normal limits.Used on gas powered modelServosMount the servos as recommende d in your model's instruction manual,Follow these general guidelines for servo mounting.Receiver installationNote the location of the receiver in your model's instruction manual or buildingplans.NOTEWe assume that all areas where large currents are flowing are generatingnoise, and noise is a type of radio wave. It is important to reduce thepossibility of interference by locating a fine position for receiver andantenna.HELPFUL HINTAlways install the receiver as far as possible from the motor, ESC,NiCd/NiMH batteries, motor wire or other noise sources. Especially,do not route the motor wire next to the receiver, crystal or receiverantenna.Noise suppression capacitors should be installed on almost all motors.If the proper capacitors are not installed, high frequency noise willreduce range and cause loss of control along with various other problems.Make sure your motor is equipped with noise suppression diodes orcapacitors.NOTEFET servo wire (7.2V) can also generate noise, position them as faraway as possible from the receiver and the antenna.ReceiverSwitchHarness |
Related manuals for ACE RC Sea Commander T6M 8603
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved