Menu
ABSTRACT Twister4 HP Manual
  | |
Contents | 
Page 4Dip switch settings for 4 channel controllersMaintenanceKeep the lens clean using a soft damp cloth.Regularly remove dust and fluff from the fan cooling vents or the unit mayoverheat.To replace the lamp, first disconnect the mains power and wait for the unit tocool if it has been running. Remove the panel under the lens. Remove the oldlamp by sliding it out of the metal clip. Pull the connector off the lamp pins. Plugonto the new lamp and refit into clip. Replace cover.Lamp type A1-259 (24V, 250W)issue 1.1 © AbstractAVR Limited 2004Tel 0116 278 8078 http://www.abstract.uk.comTwister4 HPThe Twister4 HP is the first in a range of Abstract “HP” products.This sheet gives you a quick guide to how it works.Setting the unit upThese controls and connectors are located on the end of the unitopposite to the output lens.1: (socket) DMX output or link through. Plug “slave” units in here.2: (plug) DMX input, for a DMX desk or if this is a slave unit in astand alone system. Note: Pin 2 is “hot data”3: Power On indicator (red)4: DMX received, or Sound Beat indicator (green)5: DMX address or Sound Option dip switches6: MicrophoneThere is a rocker switch next tothe mains input on the rear ofthe unit which dims the lampslightly to extend lamp life.Connect 240V mains to the IECmains power input. When youconnect power the unit will gothrough a short setup routine,and will then begin to produce alightshow to sound, or if DMX isconnected, will respond to theDMX input.Focus the beam output by loosening the two screws on the top ofthe case and sliding the lens back or forward.Stand alone modeThe Twister4 HP has an advanced stand alone light show featuringBPM sensing and product group controls. If no DMX is connected,the unit will automatically work in stand alone mode. If youconnect other Abstract units to the DMX output, they will |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved