Menu
ABIKOR BINZEL WH Series Operating Instructions Manual
                                                        | |
EN - 14 BAL.0022 • 2019-04-237 Maintenance and cleaning Alignment jig7 Maintenance and cleaningScheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.7.1 MonthlyA monthly basic cleaning is recommended, and necessary in case of extreme working conditions.8 TroubleshootingPlease observe the attached document "Warranty". In the event of any doubts and/or problems, please contact your retaileror the manufacturer.9 Disassembly10 DisposalWhen disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. To correctlydispose of the product, it must first be disassembled. 9 Disassembly on page EN-1410.1 MaterialsThis product is mainly made of metallic materials which can be melted in steel and iron works and are, thus, almost infinitelyrecyclable. The plastic materials used are marked in preparation for sorting and separation of the materials for laterrecycling.10.2 ConsumablesOil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These materials must bestored, transported and disposed of in suitable containers. Please observe the relevant local regulations and disposalinstructions in the safety data sheets specified by the consumables’ manufacturer. Contaminated cleaning tools (brushes,rags, etc.) must also be disposed of in accordance with the information provided by the consumables’ manufacturer.10.3 PackagingABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packagingmaterials is always considered during their selection.WARNINGDanger of crushingParts of the body can be crushed between the torch neck and the guide device when aligning the torch neck duringnormal operation.• Keep out of the danger zone.NOTICE• If the measures described below are not successful, please consult your dealer or the manufacturer.• Please also consult the operating instructions for the welding components, such as the power supply, welding torchsystem, coolant recirculator, etc.Fault Cause SolutionThe test block is blocked and does not returnautomatically to the basic position• Spring broken • Change the spring• Test block soiled • Clean the test blockThe torch does not fit into the clamping device • Clamping body soiled • Basic cleaningTab. 8 TroubleshootingNOTICE• Only qualified personnel are permitted to perform work on the device or system. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved