ABB SACE Tmax XT5 Operation And Maintenance Manual

Also see for SACE Tmax XT5: Manual Operating instructions Assembly instructions Manual Manual

Contents

ABB SACE Tmax XT5 Operation And Maintenance Manual Manual pdf 196 page image

ABB | SACE Tmax XT194 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A Internal accessories | 8 - Ekip Signalling 1K8 - Ekip Signalling 1KEkip Signalling 1K is a signaling accessory allowing programmable inputs/outputs to be managed.The module can be configured in the CB with the IEC standard.IMPORTANT: each circuit-breaker can house one module only; configuration withexternal modules is not allowed if an internal module is presentConnections The circuit diagrams and references concerning the terminals are available in document 1SDM000005A1001.To connect the module to Ekip Touch and to actuator MOE-E if present, please consult document1SDH002011A1507.Power supply Ekip Signalling 1K is supplied directly by the Ekip Touch to which it is connected.WARNING! communication between Ekip Touch and the module is interrupted in theabsence of auxiliary power supplyInput The input can be configured so that its status corresponds to actions or signals, with different programmingoptions (see Menu).The module permits two logic statuses, interpreted differently by the Trip unit on the basis of the selectedconfiguration:State Electrical condition Contact configuration Status detected byTrip unitOpen Circuit open Active open ONActive closed OFFClose Short-circuit Active open OFFActive closed ONOutput The output has three contacts: normally open (NO), normally closed (NC) and common.The output can be configured so that the contacts change status when one or more events occur, withdifferent programming options (see Menu).Compared to the common contact, the NO and NC contacts have the following electrical characteristics:Characteristics Maximum limit (1)Maximum switchable voltage 150 VDC / 250 VAC.Breaking capacity 2 A @ 30 VDC, 0,8 A @ 50 VDC, 0,2 A @ 150 VDC,4A @ 250 VACDielectric strength between contact and internal coil 1000 V AC (1 minute @ 50 Hz).(1) data relating to a resistive load