ABB LME620-AI User Manual

Also see for EAN823: Operating instruction Instructions

ABB LME620-AI User Manual Manual pdf 13 page image

LME620-AI / PME120-AI / EAN823 / EBN853 / EBN861 ELECTRONIC UNIT | OI/PME/LME/EAN823/EBN853/EBN861-EN REV. E 13LME620-AI / PME120-AI (with integrated EAI823electronic unit)Refer to the operating instruction of the linear actuator or rotaryactuator for detailed information on the assembly of actuatorswith integrated electronics.EAN823 / EBN8531. Fasten the electronic unit to a vertical mounting plate usinggrade 8.8 screws. Tensile strength 800 N/mm 2(116032 pounds/square in.), yield strength 640 N/mm2(92826 pounds/square in.).2. Provide adequate room for installation and ensure easyaccess.3. The cable entries must be directed to the left.EBN861NoteThe total weight of the electronic unit is 40 kg (88 lbs). For thisreason, the electronic unit is equipped with a load-bearingeyelet.If, for technical reasons, the load-bearing eyelet cannot be used,the two halves of the housing can be installed separately.Separating the housing halves1. Place the electronic unit on a horizontal surface.2. Unscrew the cover screws(Figure 3 on page 6).3. Flip open the electronic unit cover.4. Disconnect the internal plug connection between the housinghalves.5. Close the electronic unit cover.6. Unscrew the hinge screw (Figure 3 on page 6).7. Flip the electronic unit cover forward while lifting it up andoff the hinge pin. Precisely guide the cover of the electronicunit cover in the process.Mounting1. Fasten the electronic unit or the lower part of the electronicunit to the vertical mounting rail of the mounting rack usinggrade 8.8 screws. Tensile strength 800 N/mm 2(116032 pounds/square in.), yield strength 640 N/mm2(92826 pounds/square in.).2. Provide adequate room for installation and ensure easyaccess.3. The cable entries must be directed down.Mounting the housing halves1. Set the electronic unit cover down on the hinge pin and screwin the hinge screw. Precisely guide the cover of the electronicunit cover in the process.2. Reconnect the internal plug connection.3. Close the electronic unit cover and screw in the cover screws(Figure 3 on page 6).Change from two to one column