ABB Foundation LD 810HSE Ex Quick Installation Manual

Also see for Foundation LD 810HSE Ex: User manual

ABB Foundation LD 810HSE Ex Quick Installation Manual Manual pdf 17 page image

2PAA118721 | Quick Installation Guide LD 810HSE Ex 17As indicated in the connection diagram, the power can be appliedalternatively by a special DIN rail connector (Rail Power Supply).For further information contact ABB.Ethernet PortsThe Linking Device is equipped with two 10/100 Base-T Ethernet interfacereceptacles (RJ45). Ethernet port 1 (ETH 1) is intended to be connected to aFOUNDATION™ High Speed Ethernet system (HSE). Do not use Ethernet port 2(ETH 2). It is reserved for future use. The Ethernet port corresponds to the IEEE802.3 with the pin assignment shown in the following table.Ethernet Port 1 (ETH 1)Pin Signal Description1 TX+ Transmit signal positive2 TX− Transmit signal negative3 RX+ Receive signal positive4 Not used Drain wire5 Not used Drain wire6 RX− Receive signal negative7 Not used Drain wire8 Not used Drain wire