ABB EGNL Series Quick Start Manual

ABB EGNL Series Quick Start Manual Manual pdf 1 page image

Tel: (888) 552-6467 Fax: (800) 316-4515 06/20 750.2103 Rev. AEGNL Series Vandal Resistant Emergency Light1/2© 2020 ABB. All rights reserved.EGNL Series Vandal Resistant Emergency LightAC, AC/DC and Self-poweredUse Flexible Conduit OnlyIMPORTANT SAFEGUARDSWhen using electrical equipment, basic safety precautions should alwaysbe followed including the following:READ AND FOLLOW ALL SAFETYINSTRUCTIONS1. All servicing should be performed by qualified service personnel.2. Disconnect power at fuse or circuit breaker before installing or servicing.3. All electrical connections must be in accordance with local codes,ordinances and the National Electric code.4. All unused wires must be capped to prevent shorting.5. Do not use outdoors.6. Do not let power supply cords touch hot surfaces.7. Do not mount near gas or electric heaters.8. Equipment should be mounted in locations and at heights where it will notreadily be subjected to tampering by unauthorized personnel.9. The use of accessory equipment not recommended by the manufacturermay cause an unsafe condition.10. Do not use this equipment for other than intended use.11. Use caution when handling batteries (self-powered only).12. Allow battery to charge for 24 hours before first use (self-powered only).SAVE THESE INSTRUCTIONSInstallation Instructions1. Turn off AC power.2. Feed AC unswitched circuit of rated voltage into junction box and leave 6”of wire length.3. Using a flat head screwdriver, insert the blade into the slots and tilt torelease the latch and open the front cover (see figure 1).4. Push in the locking clips located on each side of the reflector and removethe reflector assembly (see figure 1).Wall and Ceiling Mount1. Remove the appropriate knockouts in the back plate.2. Feed AC wires through the center hole into the back plate.3. Mount and secure the back plate to the junction box. Ensure the gasket iscompressed tightly to the surface.4. Make the proper connections according to model configuration:For self-powered see figure 3.For AC, AC/DC see figure 4.5. Attach safety cable from housing to reflector assembly.6. Connect battery connector to PCBA.7. Reattach reflector assembly. Push in the locking clips located on each sideof the reflector and snap in reflector assembly (see figure 1).8. Adjust LED strips as required (see figure 6).9. Snap in the lens.Note: for units with auto-test option, ensure button on lens aligns withtest switch on reflector.IMPORTANT: Maximum mounting height: 22 feet from floor.WARNING:Risk of Shock.Disconnect Power before Installation and Maintenance.Figure 1Reflector locking clip locationSlot locationto open front coverBack plateWire nutsGasketReflectorFigure 2Figure 3RedWhite (Neutral)Black (120 to 347VAC)Wall switchBatteryLED 1LED 2TestLEDWiring diagram for self-powered modelsPCBAindicatorswitchWith wall switchWithout wall switchRedWhite (Neutral)Black (120 to 347VAC)BatteryLED 1LED 2PCBAConnect the black and red wires to hot lead, white wire to the neutral asshown below.Connect the black wire to 120/347Vac, white wire to the neutral.Connect the red wire to one contact of the wall switch and conect theother contact to the black wire as shown below.TestLEDindicatorswitch

/ 2

Related manuals for ABB EGNL Series