376.3 Totals Page DisplaysThis page is omitted from both faceplates if the Totalizer Option is not fitted. The page is also omitted from faceplate 2 if both Totals2 and 3 are set to OFF and from faceplate 3 if both Totals 3 and 4 are set to OFF – refer to the Set Up Totals Page in the AdvancedSoftware Options Manual.Front Panel (Batch) Flow Total 2 (3)The batch flow total is calculated from processvariable 2 (3).The flashing channel l.e.d. indicates the flow totaldisplayed.Example – a flashing channel 2 l.e.d. indicates FlowTotal 2 parameters displayed.Counter ResetThe Front (Batch) Flow Total can be reset to the PresetValue in Set Up Totals Page if Reset Enable in Set UpTotals Page is set to 'ENbL–Y'.Select 't2 YES' to reset the counter ( 't2' indicatesFlow Total 2 ).V Note. If the Counter Reset is disabled in Set UpTotals Page, the counter reset frame is omitted.Counter Stop/GoSelect 'GO' to start the counter or 'StOP' to stop it.V Note. If the Counter Stop/Go is disabled in SetUp Totals Page, the frame can be viewed but notaltered. If a digital signal is assigned to the TotalizerStop/Go source, an active digital signal sets thecounter to GO and the Counter cannot be stopped fromthe front panel.Front Panel (Batch) Flow Total 3 (4)Repeat the above procedure for Flow Total 3 (4).V Note. The number of totalizers is dependent onthe number of pens fitted to the instrument e.g. a 3 peninstrument has 3 totalizers.t_YESIf YES selectedGORepeat for Total 4 (if applicable)Repeat for Total 3 (if applicable)t_YESt_NOGOStOPCH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL4CH1CH2CH3CH4AL1 AL2 AL3 AL412345678tOtALSPAGErESEtt2 NOCOUNtStOP1234567887654321COUNtStOPtOtALSPAGErESEtt3 NO876543218765432112345678Flow Total 2 and 3Flow Total 2 and 3 Flow Total 3 and 46 RECORD OPERATION…