ABB Aztec 600 Operating Instruction

Contents

ABB Aztec 600 Operating Instruction Manual pdf 24 page image

Aztec 600 ISE ammonia and fluorideSingle-stream ion-selective analyzers 4 Getting Started22 OI/AXM630–EN Rev. I4 Getting Started4.1 OverviewThe following procedure describes how to start up andconfigure the analyzer prior to operation.1. Ensure the analyzer is installed and electrically connectedcorrectly – see Section 3, page 10.2. Ensure the correct reagents / calibration solutions areconnected to the analyzer – see Section 3.6, page 17.3. Ensure sample is connected correctly to the analyzer andthat the flow rate, temperature, pressure and particulatesize are within the specified limits – see Section 14,page 70.4. Switch on power to the analyzer.After an initial power-up period, the main operator screenis displayed.5. Press the key and use the and keys to select'Common Configuration' to configure the analyzer:– Setup – see Section 6.1.1, page 28– Screen – see Section 6.1.2, page 28– Time – see Section 6.1.3, page 29– Security – see Section 6.1.4, page 30– User – see Section 6.1.5, page 33– Operator Messages – see Section 6.1.6, page 336. Press the key and use the and keys to select'Measurement' to set up the analyzer's measurementparameters:– Setup – see Section 6.2.1, page 34– Streams – see Section 6.2.2, page 347. Press the key and use the and keys to select'Exit' to exit configuration. A prompt is displayed asking ifthe current configuration is to be saved:8. Press the key to save the configuration to theanalyzer’s internal memory.9. Press the key and use the and keys to select'Operate' followed by 'Flush Monitor' and press thekey.Allow the analyzer to flush for a minimum of 1 hour toenable the measurement probe to stabilize.