Single and Dual Input Analyzers for Low Level ConductivityAX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456 6 INSTALLATION52 IM/AX4CO Issue 116.2.2 Panel-mount AnalyzersFig. 6.4 Overall DimensionsNote. The clamp must fit flat on the analyzer casing. If the clamp is bowed, the securing screw is overtight and sealing problemsmay occur.Fig. 6.5 Panel-mountingDimensions in mm (in.)96 (3.78)96 (3.78)5.40 (0.2)91.60 (3.6)137.50 (5.41) 25(0.98)Panel Cut-out+0.8–092 (3.62 )+0.03–0+0.8–092(3.62 )+0.03–0Insert the instrumentinto the panel cut-outSecure the analyzer by tightening the panel clampretaining screws (see Note below)Loosen theretaining screw oneach panel clampRemove the panel clamp andanchors from the instrument caseCut a hole in the panel (see Fig. 6.4 for dimensions).Instruments may be close stacked to DIN 43835123456Refit the panel clamps to the case, ensuring that thepanel clamp anchors are located correctly in their slots
