ABB 2CSYD0301N Usage Manual

ABB 2CSYD0301N Usage Manual Manual pdf 1 page image

12CSYD0301N1 GENERAL DESCRIPTIONThe Remote control is a portable device that enables to interact withthe control unit.It encompasses 5 keys that can be configured and linked to thefunctions related to the arming and disarming of the anti-intrusionareas or to special functions such as burglary alarm, panic alarm, aidalarm, operations or system status request.The Braille characters enable an easy usage of the device also byvisually impaired people.Through the configurable LEDs, it is possible to know the status ofthe areas.2 ACQUISITION ANDPROGRAMMINGTo let the control unit acquire the remote control:1. Power the remote control by removing the isolatingprotection of the battery (please refer to the section Batteryreplacement for details about how to open the remotecontrol).2. On the control unit, activate the remote control acquisitionmode.3. Press any key on the remote control so that it can beacquired by the control unit.4. Program the remote control (keys and LEDs).Programming details are encompassed in the control unit installationmanual.3 USAGEIMPORTANT NOTE! As keys and LEDs (except LED 1) arefreely configurable, the function linked to each of them shall becommunicated to the user by the installer.Each remote control can be configured in a different way.When you press a key, the remote control sends the relevantcommand to the control unit.LED 1 indicates if the control unit replied.3.1 LEDsLED 1 is a standard LED and cannot be configured. Signals providedby LED 1 when any key is pressed are the following:LED turns on green: Full batteryLED turns on red: Voltage of the battery lower than 2.7 VLED turns on after 1 sec: The control unit does not replyLED turns on after 0.2 sec: The control unit repliedLEDs 2, 3, 4 and 5 can be separately configured and provide thefollowing indications:LED turned off: The LED is not configuredLED turns on green for 2seconds:Anti-intrusion area/s disarmedLED turns on red for 2seconds:Anti-intrusion area/s armedAll LEDs turn on orange for 2seconds:Arming/disarming block on the controlunitWhen you receive an arming block signal, it is possible to force theblock by sending the command again.2CSYD0301NRemote controlEN Usage manual

/ 2

Related manuals for ABB 2CSYD0301N