AAXA Technologies P300 User Manual

Also see for P300: User guide User guide

AAXA Technologies P300 User Manual Manual pdf 7 page image

Getting Started1. Connect the power cord to the P300.2. Connect the wall plug into the wall power source.3. Switch the On / Off switch on the side of the projector to the “ON” position to enter“standby” mode4. Press POWER button on the keypad and hold for 2-3 seconds to start the projector5Powering ON the projectorChapter 2Powering OFF the projector1. Press and hold the power button on the keypad for 3 seconds.2. The optical engine should power off and the fan should stop spinning. The projectoris now in “stand by mode” and can be turned on using the remote control. “Stand bymode” consumes a little bit of power3. To fully turn off the projector, switch the On / Off switch on the side of the projector tothe “Off” positionNote: The P300 Projector battery does not charge when it is in operation.