Menu
AAMP Global Stinger SPXWPRGB4D Manual
  |
SPXWPRGB4D86 85308787a12V+5 AMPFUSE5 AMPFUSE1. Mount the base in desired location. Thebase requires a 1/2”/ 13mm mounting hole.2. Connect extension wire to the Red andBlack wires and route wiring to the battery orswitch / relay location.3. Refer to diagrams for wiring.Diagram 1: Wiring direct to power and usingremote control to turn on/off. Must add 3AMP fuse on RED 12V+ wire.Diagram 2: Wiring with a switch. You canadd a new dedicated switch or use anexisting light switch that outputs 12V+ whenON. You will need to add a 3 AMP fuse onthe RED 12V+ wire and also requires a 12Vrelay.Inline Fuse Holder (SPXATC16 or similiar)5 Amp Fuse2 Strand Primary WireWire Connectors / SolderWire CoverZip-TiesOptional:SwitchRelay Diagram 1Diagram 2DYNAMIC RGB LED LIGHTED WHIPwith QUICK DISCONNECT WHAT’S INCLUDED4’ Dynamic LED WhipMounting BaseFlagZip-Tie for FlagMounting Base CapBefore you start, read directions completely.If your vehicle is not pre-wired for external lighting,you may need the following:ON4. Attach whip and test.To attach or release the whipfrom the base, pull up on thelocking collar.O O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O OO O O O O O O O O O ODynamic RGB ControllerSold SeperatelyDynamic RGB ControllerSold SeperatelyThe SPXWPRGB4D Dynamic RGB Whip requires aDynamic RGB Controller which is sold seperately |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved