Menu
AAL Homecare Profiline Instruction Manual
    | |
Contents | 
INSTRUCTION MANUALAAL Profiline Large Momentary Call SwitchHC-105-BA V1.08 Large momentary call switch Page 1 of 4AAL Homecare Fon +49 (0) 2208 9339170 Fax +49 (0) 2208 9339063 www.aal-homecare.comWarningThe use of a call device does not release supervisors from the obligation to supervise the personssupported by such a device. This system is radio-based and must therefore not be used formonitoring purposes if life-threatening conditions are foreseeable.Package contentsProduct Order number1 Frequency1AAL Profiline wireless large momentary call switch, incl.batteryHC-105 869.23 MHzInstruction manual HC-105-BA1Order number and frequency can be found on the identification decal on the bottom side.Note: While unpacking, each shipment should be inspected for completeness and damage.Note: In this manual, the AAL Profiline large momentary call switch is referred to as “large momentary callswitch”.Use and FunctionsA call is triggered by applying a slight pressure on the large red bellows. Thus the large momentary call switch is alsosuited for persons with greatly limited motor skills.PlacementPlace the product such that the user can reach it with the part of the body intended to trigger the call. If possible, turnthe LED indicator towards the user so that he or she can see when it illuminates.Fig. 1: large momentary call switchPutting into operationThe large momentary call switch is supplied ready for operation, incl. battery. During initial putting into operation theswitch must be programmed in a suitable AAL Profiline receiver and a range test must be performed.Programming / deleting the large momentary call switch to / from a radio receiverThe “programming” to the radio receiver required for initial putting into operation and the “deletion“ from the radioreceiver that may be required if the transmitter is ported to another radio receiver can be found in the instructionmanual of the respective radio receiver.Switch off call messagesWhen actuated, the large momentary call switch sends one radio call signal to the respective receiver. This call signalcan be switched off at the receiver. It is not possible to reset the call signal at the large momentary call switch.LED indicator.Illuminates upon triggering of a callPressure-sensitiveareaThe transmitter module and the battery areaccessible after removing the rear element.Practical exampleCall: 5 flashes“Battery low” message: 1 flash |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved