Menu
A-Tach Mounts 50189 Quick Start Manual
  |
A-Tach # 50189Designed for: Honda Ridgeline 2006 – 2014ST-1 A-TachMountsNOTICE: A-Tach Mounts will not be responsible forany damage to the vehicle due to the installationand/or use of the product. The product has beentested to fit securely to the listed vehicles.Instructions are provided for your convenience.You are responsible for the use of the product andto determine if you have the skill to attach theproduct without causing damage to your vehicle orthe product.Read all instructions and view the photos beforeattaching this product.For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFOREattaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often themount will appear to be a little too big or small for the intended location. The vehicle mount must beinstalled BEFORE a device holder is screwed onto the vehicle mount.Once screwed together the products are considered used and non-refundable.The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.Once it is attached, it should remain attached until you would like to permanently remove it.WARNING: AVOID extreme heat conditions. It can damage the device and the mount.(1) Clean the area where the mount will attach.The mount will attach into the two seams illustratedwith the arrows in the photo.(2) Insert the thin edge of the seam tool into thetop seam to open the seam a little. The specificlocation is important due to tabs under the dash.(3) Remove the covering from the tape. Insert themount into the seam.(4) There are tabs under the dash that might blockthe mount from going all the way into the seam soslide the mount over until the mount edge goes allthe way into the seam.See additional instructions on the back side. |
Related manuals for A-Tach Mounts 50189
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved