Menu
80TAPE IN LIMBO III Manual
  |
IN LIMBO III - MULTI TAP MANUAL 80TAPE FXDunedin, New Zealandemail: jonny@80tape.comMulti Tap Switches:This unit has two multi tap toggle switches with 1/3, 2/3, 3/4 and 1/2 settings. Both of these switches have acentre off position to enable a standard delay setup. The full output (1/1) tap can also be switched on or off, toallow shorter delay times. Multi taps have their own separate regeneration path which can be switched on oroff. Take care when using this at high regeneration settings as the more you add in to the regeneration paththe sooner it will self oscillate. See the below simplified signal path.POWER SUPPLY NOTES:Voltage: 9V DC (negative tip - standard Boss style 2.1mm connector)Typical current draw: 150mA (recommended 200mA and above rated power supply)CV Input range: 0 to +5VEXT tap: Active LOW (Expects to be pulled to GND)Where possible avoid daisy chaining this unit to avoid interfernce.Changing subdivision:Hold the tap tempo switch for one second then turnthe DELAY control a quarter turn in any direction.Next, move the dial to the desired subdivision asshown on the right release the tap tempo buttonwhen in place to set. The setting will be saved andrecalled for next use.DELAY31 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved