OneStart

Menu

4B IE-NODE Series Operation Manual

Also see for IE-NODE 2: Operation manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Contents
  1. installation instructions
  2. Table Of Contents
  3. CUSTOMER SAFETY RESPONSIBILITIES
  4. PRODUCT OVERVIEW
  5. APPROVALS
  6. DIMENSIONS
  7. SENSOR PLACEMENT DIAGRAMS
  8. ELECTRICAL CONNECTION
  9. WIRING DIAGRAMS
  11. Individual Speed Sensor Wiring Diagrams
  12. IE-NODE OPERATION
  13. DIP Switches (SW2)
  14. Internal Temperature Sensor
  15. IE-NODE NETWORK CONFIGURATOR SOFTWARE
  16. TROUBLESHOOTING GUIDE
  17. PRODUCT WARRANTY
4B IE-NODE Series Operation Manual Manual pdf 7 page image
PAGE 74. APPROVALSETH-NODE1V46CAI Approvals InformationCSAClass II, Division 2, Groups F and G T130°CTamb: -20°C to +50°CATEXBaseefa11ATEX 0033XEx II 3D Ex tc IIIC T125°Dc IP66TAMB -20°C to +45°CIECExIECEx BAS11.0018XEx tc IIIC T125°Dc IP66TAMB -20°C to +45°CETH-NODE1V4CAI Approvals InformationCSAClass II, Division 2, Groups F and G T130°CTamb: -20°C to +50°CATEXBaseefa04ATEX0131XEx II 2D Ex tb IIIC T125° Db IP66TAMB -20°C to +50°CIECExIECEx BAS05.0026XEx tb IIIC T125° Db IP66TAMB -20°C to +50°CSPECIAL CONDITIONS OF USE• The equipment shall be suitably earth bonded via the PCB mounted earth terminal inside theequipment enclosure.• Warning: The equipment is a potential static hazard, clean only with a damp cloth.• Do not allow dust layers to build up on the equipment.
/ 28
This manual is suitable for:
IE-NODE 2ETH-NODE1V46CAIETH-NODE1V4CAIIE-NODE 1IE-NODE Series
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved