3e Technologies International AirGuard 3e-525C-2 User Manual

Contents

3e Technologies International AirGuard 3e-525C-2 User Manual Manual pdf 74 page image

3e–525C–2 Wireless Access Point Chapter 4: Wireless Bridge Configuration66 29000155-001 AAs stated previously, complete any other setup screens following generalinstructions in Chapter 3.Repeater Bridge ConfigurationA repeater setup can be used to extend the wireless signal from one bridgeconnected to an Ethernet LAN wirelessly so that another bridge can control awireless LAN at a distance.�� Repeater Bridging Setup Guide - Manual ModeDirection Bridge 1 Bridge 2 Bridge 3Wireless Bridge — General (Manual BridgingMode)Wireless Mode 802.11a 802.11a 802.11aTx Rate AUTO AUTO AUTOChannel Same as Bridge 2 Same as Bridge 1 Same as Bridge 1Tx Power Mode Auto Auto AutoPropagation Dis-tance< 5 Miles < 5 Miles < 5 MilesBridging Mode manual manual manualSignal StrengthLED MACNot Assigned(select from drop-down list)Not Assigned (selectfrom drop-downlist)Not Assigned (selectfrom drop-downlist)Spanning TreeProtocolEnable (or Disableif no bridging looppossible)Enable (or Disableif no bridging looppossible)Enable (or Disableif no bridging looppossible)BSSID Add Bridge 2'sMACAdd Bridge 1's andBridge 3's MACAdd Bridge 2's MACWireless Bridge — EncyptionWireless Configu-ration – BridgingEncryptionSelect appropriatekey type/lengthand enter keyvalue. Must be thesame as that on theother 2 Bridges.Select appropriatekey type/lengthand enter key value.Must be the same asthat on the other 2Bridges.Select appropriatekey type/lengthand enter key value.Must be the same asthat on the other 2Bridges.