Menu
3Disc FireCR Flash User Manual
                                                                                                                                                                       | |
Contents
| 
User ManualFireCR Flash TM-401-EN213.6.2. Connect the Power Cord1. Connect the power cord to the reader, located on the rear side.2. Connect the other end of the cord to a grounded power outlet.3.6.3. Installation ReportAfter installation of the reader, fill in Installation Report from (Appendix I) and send to 3DImaging & Simulations Corp. service department by fax or e-mail.Fax : +82-42-931-2299E-mail : support@3DISCimaging.comD ANGERThis equipment must only be connected to supply mains withprotective earth. Use only a three-wire cord that has grounding.This is a safety feature. If you are unable to insert the plug intothe outlet, contact your electrician to replace your obsolete outlet.Do not defeat the safety purpose of the grounding-type plug.W ARNINGSocket-outlet shall be installed near the device and shall be easilyaccessible.Do not place the device where difficult to access to appliance inlet.Do not unplug the power cord or turn the power switch off duringscanning.D ANGERDo not use any power cord other than the power cord includedwith the system. Doing so may lead to fire, electrical shock, orelectrocution. |
Related manuals for 3Disc FireCR Flash
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved