3D Systems cube User Manual

Also see for CUBE: User guide Quick start guide Quick start guide User guide User guide

Contents

3D Systems cube User Manual Manual pdf 82 page image

783D Systems, Inc.11 CUBE MAINTENANCEGENERAL CLEANINGWaste material from the printing process can accumulate inside the printer Using a slightly damp, lint-free cloth, wipe the interior of theCube, including the print pad and anywhere else you might find pieces of plastic waste material. Print material can also collect aroundthe belt area on the left side of the printer This area should be checked periodically and any print material found should be removedREMOVING WASTE FROM THE JET WIPER PURGE BINSIn addition to having scrapers to clean the print jet nozzles, the jet wiper assemblies are also purge bins collecting print material thathas been primed from the print jets. As the purge bin assemblies fill, they will need to be emptied regularly.Using the handle, pull the purge bin assembly inward at the top and then upward to free the bottom tab from the slotNOTE: Note the tab at the bottom of the purge bin. This tab is designed to fit into a slot for proper installation.CAUTION: When removing or installing the purge bin assemblies, be careful not to damage the bottom tabsEnsure the purge bin assemblies are installed properly before using the printerA BCAHandleBJet wiperCPurge bin tabLeft Purge BinAssembly