3D Systems Cube User Manual

Also see for CUBE: User guide Quick start guide Quick start guide User guide User guide

Contents

3D Systems Cube User Manual Manual pdf 32 page image

283D Systems, Inc.7 PRINTING YOUR CREATIONThere are many 3D creations available at www cubify com In addition, you can create your own with Cubify Invent and Cubify Sculptsoftware available at www.cubify.com. The printer can only print .cube3 files. Other file formats like .stl must be processed throughCubify software before they can be printedFor more information about converting other 3D files to .cube3 print files, refer to the section titled Cubify SoftwarePRINTING PROCEDUREThe following procedure illustrates how to print a creationCaution: Ensure the print pad is clean before printingNOTE: For best results, perform the Auto Level and Auto Gap procedures before your first print.NOTE: After every 10 prints, the printer will prompt you to perform the Auto Level and Auto Gap procedures1 After powering on your printer, press the touchscreen to begin2 Select PRINTNOTE: If the file is saved on a USB mass storage device, insert thedevice into the USB inlet port on the printerNOTE: You may also send the file from Cubify software to theprinter using a wireless connection. Wireless transfer of print filesusually takes more time than USB mass storage device transfer3 Using the arrows, navigate to the file name of your creation. Select PRINTNOTE: The file name will appear at the top of the display.