3Com 4500 Getting Started Manual

Also see for Switch 4500 Family: Product guide Datasheet Datasheet Datasheet Datasheet

Contents

3Com 4500 Getting Started Manual Manual pdf 31 page image

Packing and Shipping the Switch 4500 313 Gently slide the transceiver into the SFP port until it clicks. If the transceiver doesnot click into place, remove it, turn it over and re-insert.4 Remove the plastic protective cover if fitted.Figure 8 Inserting an SFP Transceiver5 Check the LEDs on the front of the Switch to ensure that it is operating correctly.Refer to “LEDs” on page 17 for more information.Removing an SFPTransceiverIf you wish to remove the transceiver (it is not necessary to power-down yourSwitch):1 Disconnect the cable from the transceiver.2 Move the wire release lever downwards until it is pointing toward you.3 Pull the wire release lever toward you to release the catch mechanism; thetransceiver will then easily slide out.Packing and Shippingthe Switch 4500This section describes how to correctly package your Switch 4500 should you needto return the Switch to 3Com.WARNING: The unit should be packaged safely to ensure that you do notinvalidate the repair.Follow these steps to ensure that you package your unit correctly:1 Orientate your Switch so that the back panel is on the left side (looking down atthe top of the unit) as shown in Figure 9.2 Secure one of the polystyrene supports to the back panel side of the unit. Securethe other support to the front panel side of the unit.3 Place the unit in the box with the back panel next to the cable packaging.Figure 9 Correct Orientation When Packing the Switch 4500ProductlabelSuitable porton host Switch