Menu
2gig Technologies 2GIG-NVR1 Installation Instructions Manual
            | |
Network Video Recorder | Installation Manual6 Copyright © 2015 Nortek Security & ControlFigure 23. Network SetupUse the Networks secƟon to set up Local Area Networks (LAN1 & LAN2).To ensure recording of the IP Cameras to the NVR, verify network connecƟvity.LAN1 should be connected to your exisƟng LAN network.LAN2 is a private network for your IP cameras.Figure 24. Storage SetupThe 2GIG NVR supports up to one (1) internal Hard Disk Drive (HDD). Priorto turning the NVR on, the HDD should be installed per SecƟon I. If the HDDis recognized, a green light next to the storage icon will appear and the word“USABLE” beneath it. If this is a new HDD, you will need to format it.To FORMAT hard drive, click FORMAT. This will take a few minutes.WARNING: Any informaƟon previously stored on the HDD will be erased.The size of the hard drive is shown in the window next to the hard drive icon. It willdisplay how many GB’s have been used and how much is leŌ available.If the HDD is shown as “NOT USABLE”, the HDD is either unrecognized, notinstalled properly or it needs to be formaƩed.To remove the HDD from the NVR, click the UNLOAD buƩon. Power off NVR andremove the hard drive.The NVR has four (4) PoE ports which is part of a private network which can beconnected to IP cameras. IP cameras can also be connected through LAN. Thenumber of IP cameras supported is four (4).Figure 25. Adding CamerasFigure 26. Adding Cameras (ConƟnued)Use the Camera Search dialog to connect IP Cameras to the NVR for recording.1. To add IP Cameras, click on the SEARCH CAMERA Ɵtle as indicated above.2. A Camera Search window will appear. Click SCAN to discover IP cameras onthe network, or by Network Range.3. There should be a list of several cameras in the window.4. The validaƟon results should indicate a successful connecƟon to the camera.5. Click the ARROW at the boƩom of the window to conƟnue.6. Select the cameras that are desired to be managed by the NVR. Click thearrows in the middle of the window to add them to the right pane (ManagedCameras).7. Click OK when finished.g g |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved