Menu
2gig Technologies 2GIG-EDG-RK A Quick Manual For Owners
Also see for 2GIG-EDG-RK: Quick start guide
  |
2GIG® EDGE Security & Smart Home System2GIG-EDG-RK | EDGE Remote KeypadProprietary & ConfidentialCopyright © 2021 Nortek Security & Control LLCIntroductionThe Remote Keypad (2GIG-EDG-RK) is a wall-mounted, full-color, touch screen interface thatprovides all of the same easy-to-use keypad functions available on the Control Panel. It isdesigned for indoor use only and gives users the ability to arm and disarm the system, see thestatus of sensor zones, and control Smart Home devices.Choose the Location for the 2GIG EDGE Remote Keypad’s BackplateBefore mounting the backplate, choose a location. Work with the end user to determine the bestlocation. Always choose an indoor location protected from temperature extremes.Recommended Tools and EquipmentTo install the system, these tools and equipment are recommended:➣ 2-Conductor Power Wire (if connecting power supply to the panel’s terminal block)➣ Drywall Saw (or equivalent)➣ Screwdrivers➣ Staple Gun➣ Wire StripperChoose the Wall LocationTo choose a wall location:➣ Always choose a location that is above ground and centrally located. Do NOT installthe Panel below ground level, because wireless range may be impaired.➣ Do NOT connect the Panel to a light switch-controlled outlet.➣ Avoid choosing a location that can be easily viewed from doors or windows.➣ Avoid choosing a location that is within reach of small children.➣ Avoid choosing a location in direct sunlight.1. Align Backplate for HoleLocationsRemove the backplate from the panel by backingout the top and bottom screws until you feelresistance.Once removed, create mounting holes and cut aslot in the dry wall for the AC power cord.2. Mount the Backplate to a WallUse the four (4) wall anchors and screws(supplied).NOTE: The Wall Anchor is the wall tamper andMUST be anchored to work.Power (Terminal)Battery Backup TerminalPower (Barrell)LEVEL NOT LEVELWall TamperIllustration displays both types of power connection:Install the 2 - conductor power wires or Barrel ConnectorBack PlateAttached to WallSecure withFastenerSTANDARDDECORABarrel ConnectorThe Barrel connector is an alternatemethod for connecting the AC powersupply to the Panel.WARNING!! Do NOT plug the powersupply into the outlet at this time.5. Connect Backup BatteryAlign pins, then carefully insert thebattery cable.NOTE: Backup Battery must beconnected before AC Power isconnected to the keypad.6. Hang the EDGE Remote KeypadPlace the backplate over the upper lip on theback of the chassis, and flip the Remote Keypaddownward and push until it clicks into place.Secure the back plate by tightening the bottomscrew.7. Install Retaining Wall Bracket and Connect the AC Power SupplyFor compliance with ANSI/NFPA 70: National Electric Code in the United States, you mustinstall the power supply retaining bracket (not required in Canada).3. Attach Hanger for Wiring(optional)Attach the panel’s third-hand hanging strap tothe hook at the bottom of the backplate for easyaccess during wiring.Edge Panel (upside down)Back PlateHanger4. Connect PowerTerminal Block Wires(DC + and DC -)Locate a wall outlet for the plug-inpower supply, but do NOT connect thepower supply to the outlet at this time.IMPORTANT: Never connect the plug-inpower supply to a switch-controlledoutlet. Do not over-tighten the terminalblock’s contact screws.OR |
Related manuals for 2gig Technologies 2GIG-EDG-RK
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved