962N TELEKOMUNIKACE a.s., www.2n.cz®6.3 List of Terminal AT CommandsBy default, all these commands start with AT. (Note: Some of the AT commands listedbelow may not be available in the current firmware versions.)Basic AT CommandsThe following command list is intended for all GSM gateways from that are based2N®on the same SW architecture. Some of the AT commands may be inaccessible for theBRI gateways.A/ ...repeat last command (without AT)I3 ...copyright & firmwareI4 ...serial number&FRES ...factory defaults & reset&V ...view active parameters (system)&VI ...view active parameters (isdn)&V0 ...view active parameters (common)&V# ...view active parameters (modules 1..2)&V9 ...view active parameters (inc. groups)&VALL ...view all group parameters&P ...view pseudo params&N# ...view network params (net 1..8)&NALL ...view all network params&A ...view autorouting table &R ...view lcr–routing table &T ...view bris + modules totals&TMOD ...view all modules totals&G##=atcommand ...send at command to module 0..1 (ended by OK from gsm)&G##=xtcommand ...send at command to module 0..1 (ended by fromuser)
