2N BRI Lite User Manual

Also see for BRI enterprise: User manual

Contents

2N BRI Lite User Manual Manual pdf 86 page image

862N TELEKOMUNIKACE a.s., www.2n.cz®6.5 LOG FilesTable of LOG Events:Type Text DescriptionPOWER [Power on] System switched on[Power off] System switched off[Warm boot] Restart of system, unknown cause[Watchdog] Restart of system by watchdog[BKPT code] CPU error: break code detected[Stack error] CPU error: stock integrity failure[Divided byzero] CPU error: dividing by zero[RETI code] CPU error: illegal using of instruction reti[NMI intr] CPU error: wrong interrupt[VOID intr] CPU error: wrong interrupt[Upgrade reset] Start of upgrade firmware procedure[Softwarereset] Reset by AT commands (at&fres…)INIT Eeprom Initialisation of eeprom (configuration)Flash Initialization of flash memory (firmware)HW–ERR (##…address of chip, RD…read value/WR…expectedvalue)Duart#####,RD/WR Error in initialization of serial controller on GSM boardSYSERR User stackerror! SW error: stock integrity failureBRDIN #08 TYP STS the board inserted (number of gsm board, type, status)BRDOUT #08 TYP STS the board disconnectedBRDRES #08 TYP STS Reset the board by AT commandALL GSMRESET CMD Reset of all GSM boards by AT commandSYSTEM RESETCMD Reset of system by command at&bsysL1–ERR (reserved)L2–ERR Error of 2. ISDN layer by Q.921A: unsol.RX(F) Received packed RR,RNR,REJ with unexpected bit F=1B: unsol.DM(F) Received packed DM with unexpected bit F=1C: unsol.UA(F) Received packed UA with unexpected bit F=1D: unsol.UA(–) Received packed UA with unexpected bit F=0E: unsol.DM(–) Received packed DM with unexpected bit F=0