Menu
GE MDS SD2 manuals
MDS SD2
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- INTRODUCTION
- Authorization Features
- PRODUCT DESCRIPTION
- Key Product Features
- Data Validation
- Accessories and Spares
- Protected Network Station
- Dual Protected Configuration
- TYPICAL APPLICATIONS
- Example Systems
- IP/Ethernet Polling
- Port Sharing with Multiple Hosts
- Report-by-Exception
- Serial Remotes with Two Serial Ports
- INSTALLATION PLANNING
- Optional DIN Rail Mounting
- Antennas and Feedlines
- DC Power Connection
- Grounding Considerations
- Serial Data Interfaces
- COM1 (Serial) Connection
- COM2 (Data) Connections
- STEP-BY-STEP INSTALLATION
- Initial Configuration
- Alternative Management Methods
- Using the Basic Setup Wizard
- Using the Remote Management Wizard
- Ethernet Connector LEDs
- Inter-Packet Gap Settings
- Antenna SWR Check
- USING THE DEVICE MANAGER
- Overview Screen
- Management Tasks
- Configuration Screens
- Device Settings
- Packet Settings
- Media Access Control
- Diagnostic Settings
- Advanced Settings
- Features
- IP Payload Configuration (1/2/3)
- Communications Ports
- IP Configuration
- Security
- Wireless Security
- Encryption Phrase
- Event Log
- Alarm Signal Configuration
- Performance
- Ethernet Statistics
- Link Test
- Ping Test
- Firmware Utilities
- TFTP Reprogramming
- Remote Reprogramming
- Verify Image
- Device Reboot
- Configuration Files
- Save/Restore Configuration
- TROUBLESHOOTING
- LED Indicators
- Major Alarms vs. Minor Alarms
- Operating Constraints
- TECHNICAL REFERENCE
- Setting Up Diagnostics
- Intrusive vs. Passive (Non-Intrusive) Mode
- OTA Reprogramming Overview
- Cancelling OTA Reprogramming
- COM1 Operating Modes
- Implementing Sleep Mode
- glossary of terms
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved