Fujitsu MAN3367 SERIES manuals
MAN3367 SERIES
Table of contents
- disk drives
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- CHAPTER 1 SCSI BUS
- Example of SCSI configuration
- Interface Signal Definition
- DATA BUS and SCSI ID
- INFORMATION TRANSFER phase identification
- Physical Requirements
- Interface connector
- SCSI interface connector (cable side) (16-bit SCSI)
- Single-ended connector pin assignment (16-bit SCSI)
- Low-Voltage-Differential connector pin assignment (16-bit SCSI)
- SCA-2 type, 16-bit SCSI interface connector (IDD side)
- SCA-2 Type, single-ended 16-bit SCSI connector signal assignment
- SCA Type, Low-Voltage-Differential connector signal assignment
- Interface cable
- Connection of interface cable
- Electrical Requirements
- Single-Ended SCSI termination circuit-2
- Output characteristic
- Low-Voltage Differential type
- LVD DIFFSENS driver specifications
- Internal terminal resistor and power supply for terminating resistor
- bit SCSI (not SCA2) terminating resistor circuit
- Usage in 8-bit/16-bit transfer mode
- Signal driving conditions
- Bus phases and signal sources
- Timing Rule
- SCSI bus data & information phase DT timing values
- Measurement point
- Fast-20 Measurement Point
- LVD ST Data Transfer measurement point
- LVD DT Data Transfer measurement point
- Bus Phases
- BUS FREE phase
- ARBITRATION phase
- SELECTION phase
- RESELECTION phase
- INFORMATION TRANSFER phases
- Asynchronous transfer mode
- Transfer in asynchronous mode
- Synchronous mode
- ST transfer in synchronous mode
- Data Group Pad field and pCRC field transfer
- Wide mode transfer (16-bit SCSI)
- Parameters used for fast synchronous data transfer mode
- STATUS phase
- Signal requirements concerning transition between bus phases
- Switching direction of transfer over data bus
- Time monitoring feature
- Bus Conditions
- ATTENTION condition
- RESET condition
- Bus Phase Sequence
- Example of bus phase transition at execution of a single command
- SCAM
- State of level-1 SCAM target
- State of level-2 SCAM target
- Ultra SCSI
- Electrical characteristics of SCSI parallel interface
- Comparison of active negate current and voltage
- Single-ended test circuit
- Low-Voltage Differential
- LVD receiver characteristics
- LVD capacitive loads
- System level requirements for LVD SCSI drivers and receivers
- SCSI bus fairness
- CHAPTER 2 SCSI MESSAGE
- Message type
- SCSI message
- Message protocol
- SCSI Pointer
- SCSI pointer configuration
- Message Explanation
- INITIATOR DETECTED ERROR message: X'05'(I T)
- MESSAGE REJECT message: X'07'(I T)
- LINKED TASK COMPLETE message: X'0A'(T I)
- CONTINUE TASK message: X'12' (I T)
- Task attribute messages
- IGNORE WIDE RESIDUE message: X'23' (T I)
- IDENTIFY message: X'80' to X'FF' (I T)
- SYNCHRONOUS DATA TRANSFER REQUEST message (I T)
- Definition of data transfer mode by message exchange
- Synchronous mode data transfer request setting
- Transfer mode setup request from INIT to IDD
- Transfer mode setup request from IDD to INIT
- WIDE DATA TRANSFER REQUEST message (I T)
- Data bus width defined by message exchange
- Wide mode setting request from the INIT to the IDD
- PARALLEL PROTOCOL REQUEST message (I T)
- TRANSFER PERIOD FACTOR field
- Valid protocol options bit combinations
- CHAPTER 3 ERROR RECOVERY
- Recovery Control
- GLOSSARY
- ABBREVIATION