Menu
Panasonic FP0 Series manuals
FP0 Series
Table of contents
FP0 Series
Table of contents
- safety precautions
- before you start
- Table of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Components
- specifications
- intelligent units
- options and additional parts
- expansion possibilities
- transistor output type units
- Discontinued Products of Programming Tool
- Parts and Terminology
- control unit types
- mode switch
- tool port
- E16YT
- current consumed by the control unit
- performance specifications
- input specifications
- output specifications
- expansion connector
- general specifications
- Names and Functions
- names and functions
- s−link controller specifications
- wiring the power supply
- sequence of turning on power supplies
- operation when power supply is turned on
- s−link system address recognition
- address setting of s−link i/o device
- judging errors from the error indicators
- judging errors address displays
- I/O Number
- control unit
- expansion i/o unit
- Adding Expansion Units
- adding expansion units
- important notes
- attachment to din rails
- installation using fp0 slim type mounting plate
- installation using fp0 flat type mounting plate
- Safety Instructions
- safety instructions
- momentary power failures
- wiring the power supply to the control unit
- input wiring
- led-equipped reed switch
- led-equipped limit switch
- output wiring
- precautions for using capacitive loads
- wiring the terminal type
- wiring the molex connector type
- wiring the mil connector type
- contact puller pin for rewiring
- wiring the rs232c port
- precautions during programming
- use of duplicated output
- handling bcd data
- handling index registers
- example of using an index register
- operation errors
- dealing with operation errors
- points to check in program
- instruction of leading edge detection method
- operation and precautions at run start time
- precautions when using a control instruction
- precautions for programming
- rewrite function during run
- cases where rewriting during run is not possible
- procedures and operation of rewrite during run
- changing program modes
- changing the set value of timer/counter during run
- method of rewriting a value in the set value area
- processing during forced input and output
- setting the clock/calendar timer (t32ct type only)
- High−speed Counter/Pulse Output/ PWM Output
- Table Of Contents
- outline of functions
- performance of built−in high−speed counter
- specifications and restricted items
- functions and restrictions
- outline of high−speed counter function
- instructions used with high−speed counter function
- sample program
- outline of pulse output function
- control mode
- i/o allocation and wiring
- instructions used with pulse output function
- sample program for positioning control
- pwm output function
- data transmission
- data reception
- system register settings
- if "yes" has been set for the start and terminal codes
- self-diagnostic function
- allowing duplicated output
- troubleshooting
- error/alarm led is on
- diagnosing output malfunction
- protect error is displayed
- i/o allocation table
- relays, memory areas and constants
- specification: power supply unit i/o link unit
- control unit and expansion i/o unit
- fp0 s−link control unit
- mounting on din rail
- fp0 slim type mounting plate
- fp0 flat type mounting plate
- detailed specifications of cables
- connection example
- table of system registers for fp
- table of special internal relays for fp
- table of special data registers for fp
- table of basic instructions
- basic function instructions
- subroutine instructions
- table of high-level instructions
- table of error codes
- ascii codes
- record of changes
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved