Menu
Zap ZAPGUN Instructions Manual
  |
5 USE aS a STUn gUnUSE A ZAP® STUN GUN oNly AS A DEfENSiVE wEAPoN. This product issuitable to be carried at all times, including walking, jogging, hiking, bicycling,entering or leaving buildings, etc. The ZAP® should only be used when youwould be justified to prevent an unwanted encounter.TURN oN/off SwiTch To oN. Push Stun Activation Trigger to discharge.Keep your hands and other body parts away from stun electrodes, as severeshock may occur.A ShoRT blAST (1/4 second) will startle an attacker, cause minor musclecontractions and can have a repelling effect.A MoDERATE blAST (1 - 4 seconds) can cause attacker to fall and can causemental confusion. It may make the assailant unwilling to continue attack, butthey will be able to get up almost immediately.A fUll blAST of 5 seconds or more can immobilize an attacker, causingdisorientation, loss of balance, falling to the ground, weaknessand leaving them dazed for several minutes afterwards.ThE ZAP® chARGE will have an effect anywhere on the body, butthe maximum effect is in areas marked with an "X" in the drawing.While using a ZAP® Stun Gun, you cannot suffer a charge-back toyour own body, even if the attacker is holding you.bATTERiES: Test fire your ZAP® Stun Gun periodically forfamiliarity, performance and reliability. You should replacebatteries when electrical arc gets weak.Always keep stun guns out of the reach of children. Keep away fromflammable gasses, as an explosion may occur. Must be 18 to purchase. iDcheck required. check state and local laws regarding product usage.X XXXX XXX2 YOUr ZaP gUnTM3 USE aS a flaShlighTStun ActivationTriggerZap ElectrodeLEDFlashlightZapElectrodeStun ReadyIndicator LightON/OFFSwitchBattery Cover• Turn on the LED flashlight bypushing the on/off switch tomiddle position.oN / off SwiTch:STUN-READyiNDicAToR liGhT• When ON/OFF Switch is inStun-Ready (DOWN) position,the red Stun-Ready lightcomes on to indicate the unitis ready for use.DowN position:STUN READYMiDDlE position:FLAShLIGhT ONLYUP position:POWER OFF4 BaTTEriESNoTE: batteries may be covered witha clear plastic film for protectionduring shipping. This plastic must beremoved for proper battery function.before using first time• Make sure your ZAP® Stun Gun is switchedto power-off position before installing thebatteries.• Open battery cover and install 3 new lithiumCR2 batteries, noting the correct polarity.Replace the battery cover.Replacement of batteries• When the electric arc of your ZAP® Stun Gungets weak, it is time to replace the batteries.• Always use CR2 lithium batteries. For bestperformance, use genuine ZAP® brandbatteries. |
Related manuals for Zap ZAPGUN
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved